Leave Your Message
Products Categories
Featured Products

Socket Weld Flange(SW) RJ Q235B ASME B16.5

A socket weld flange involves inserting the pipe end into a counterbore (recess) within the flange ring and welding around the pipe end and the outside. It comes in hub (raised neck) and hubless (counterbore only) types. The hub type offers good rigidity, minimal welding deformation, and better sealing, suitable for pressures ranging from 1.0 to 10.0 MPa. The Type B flange for vessels also falls under the socket weld category and is used where higher sealing integrity is required. In design, socket weld flanges can be evaluated as integral flanges.

    Detailed Description

    Our Socket Weld Flanges (SW) are precision-manufactured for use in carbon steel and stainless steel piping systems where high integrity and strength are required. The pipe is inserted into the flange socket and welded around the outside, resulting in a smooth bore that minimizes turbulence and erosion. These flanges are ideal for small diameter, high-pressure piping applications commonly found in petrochemical, oil & gas, and chemical industries. They comply with international standards for dimensions and material quality.

    Brief Introduction on Socket Weld Flange(SW)

    Product

     Socket Weld Flange(SW)

    Material

    Q235B、20#、A105、16MnR、15CrMo、304/304L、316/316L、321

    Standard

    HG/T 20592-2009、ASME B16.5、EN1092-1、JIS B2220

    Nominal Diameter

    Below DN80

    Ends

    Raised Face (RF), Male-Female Face (MFM), Tongue-Groove Face (TG),Ring Joint Face (RJ)

    Applications on Socket Weld Flange(SW)

    Boilers and pressure vessels, petroleum, chemical engineering, shipbuilding, pharmaceuticals, metallurgy, machinery, stamping elbows, food and other industries.

    Quality control on Socket Weld Flange(SW)

    1 ) Socket Dimensions & Fit Tolerance.
    Strict inspection of socket inner diameter and pipe-wall clearance (≤0.4mm)
    Verify 45° bevel angle tolerance (±1° per ASME B16.11)
    Check socket depth with go/no-go gauges (±0.5mm)

    2) Welding Process Control.
    100% penetrant testing (PT) for full-perimeter fillet welds
    Post-weld heat treatment (PWHT) hardness control: carbon steel ≤200HB
    Root gap requirement: 0.8-1.6mm (ensures full penetration)

    3) Pressure & Seal Verification.
    Pneumatic test at 2.0x design pressure (ISO 15649)
    Helium leak test for mated assemblies (≤1×10⁻⁶ mbar·L/s)
    Metallographic examination of weld fusion zone (no lack of fusion/slag inclusions)

    Leave Your Message

    Your Name*

    Phone Number

    Country

    Message*